Brake Pressure Modulator Valve (BPMV) Replacement (W/O JL4)

Brake Pressure Modulator Valve (BPMV) Replacement (w/o JL4)

Removal Procedure

1. Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.

Important: The area around the electric hydraulic control unit (EHCU) MUST be free from loose dirt to prevent contamination of disassembled ABS components.

Thoroughly wash all contaminants from around the EHCU.





2. For cutaway vehicles, remove the splash shield.
3. For AWD vehicles, remove the torsion bar.
4. Disconnect the electrical harness connectors from the electronic brake control module (EBCM).
5. Important: Make sure that brake lines are tagged and kept in order for proper reassembly.

Disconnect the brake lines from the brake pressure modulator valve (BPMV).





6. Remove the bolts securing the EHCU mounting bracket to the frame rail.
7. Remove the EHCU from the vehicle.





8. Remove the bolts (4) securing the BPMV (1) to the EHCU mounting bracket (3).
9. Disconnect the 2-way ABS pump motor connector.

10. Important: Do not reuse the EBCM mounting bolts. Always install new bolts.

Remove the bolts from the EBCM (2).

11. Important: Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.

Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
12. Clean the EBCM to BPMV mounting surfaces with a clean cloth.

Installation Procedure





1. Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

Install the EBCM (2) onto BPMV (1).

2. Notice: Refer to Fastener Notice in Service Precautions.

Important: Do not reuse the old mounting bolts. Always install new EBCM bolts with the new BPMV.

Install the EBCM bolts.
Tighten the bolts to 5 Nm (44 inch lbs.) in an X-pattern.
3. Connect the 2-way ABS pump motor connector to the EBCM.
4. Install the BPMV (1) to EHCU bracket (3).
5. Install the BPMV (1) to bracket retaining bolts (4).
Tighten the bolts to 9 Nm (80 inch lbs.).





6. Install the EHCU to the vehicle frame.
Tighten the 3 EHCU bracket bolts to 25 Nm (18 ft. lbs.).
7. Connect the 2 electrical harness connectors to the EBCM.

8. Important: The brake pipes are held in place by a plastic bracket mounted to the frame. Make sure that the brake pipes stay in the correct place for proper reassembly.

Install the 5 brake pipes to the BPMV.
Tighten the brake pipe fittings to 30 Nm (22 ft. lbs.).
9. Install the torsion bar.





10. For cutaway vehicles, install the splash shield.
11. Bleed the brake system.
12. Bleed the ABS brake system.