Ignition Lock Cylinder Case

Ignition Lock Cylinder Case Replacement
Removal Procedure

1. Caution: Refer to SIR Caution in Service Precautions.

Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
2. Remove the ignition switch.
3. Remove the turn signal cancel cam.
4. Remove the park lock cable from the lock cylinder housing.





5. Remove 3 TORX� screws.
6. Remove the lock cylinder housing from the steering column.

Installation Procedure





1. Notice: Refer to Fastener Notice in Service Precautions.

Install 3 TORX� screws into the lock cylinder housing.
^ Tighten the TORX� screws to 7 Nm (62 inch lbs.).
2. Install the turn signal cancel cam.
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch.
5. Enable the SIR system.