Exterior Trim - Front License Plate Installation
88geo01Subject: FRONT LICENSE PLATE INSTALLATION
Model and Year: 1989 GEO TRACKER
Number: 89-04-10
Section: 10
Date: SEPT., 1988
TO: ALL CHEVROLET DEALERS
This information is to be added to page 2 of Section 2B in the 1989 GEO Tracker service manual.
This bulletin has been written to inform Dealer Technicians of the procedure for installing the front license plate on the 1989 Geo Tracker.
Many states do not require front license plates; therefore, the license plate mounting holes are not drilled through the attaching pad on the front facia. Use a drill diameter of 7/16" minimum to 1/2" maximum to drill the holes 1/8" above the dimples, located on the attaching pad on the front facia (refer to the illustration).
The expandable fastener supplied with the vehicle should be installed in the drilled holes and after the license plate is attached, tighten to 1.9 N-m.