Setting Security Code

The security code is a four-digit numeric code established by the operator. Once set, if the system loses power for any reason, the security code must be re-entered before the system will again operate. Refer to Unlocking System After Power Loss. To enter the security code:
1. Write down any four-digit number and keep it in a safe place.
2. Turn the ignition switch to the ACC or ON position.
3. Turn the audio system off.
4. Press the 1 and 4 buttons together. Hold them down until "- - - -" appears on the display.

Important: The audio system is now ready to accept the security code. A delay of more than 15 seconds between steps will return the system to the radio mode.

5. Press the and/or button(s) and 0000 will appear on the display.
6. Press the 7. Press the SEEK> button and hold until the second digit of the code appears, then release the button.
8. Press the 9. Press the TUNE> button and hold until the fourth digit of the code appears, then release the button.
10. Check that the code entered is correct. If it is not, press appropriate button(s) (refer to Steps 6-9) to correct wrong digit(s). When correct, press the AM-FM button. "REP" will appear on the display, which means you must repeat Steps 5-9, then proceed to Step 11.
11. Check that the code entered is correct. If it is not, press appropriate button(s) (refer to Steps 6-9) to correct wrong digit(s). When correct, press the AM-FM button again. The display will now show "SEC" (secured).