Throttle Position Sensor: Testing and Inspection

TP Sensor Output Check Table:

TOOL REQUIRED
J 39200 Digital Multimeter

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Throttle Position (TP) sensor electrical connector.

MEASURE
Throttle Position (TP) sensor resistance according to the chart in the accompanying image. If TP sensor resistance is not within the specified ranges, adjust or replace TP sensor. Refer to either Adjustments or Service and Repair for the appropriate procedure.

INSTALL OR CONNECT
1. TP sensor electrical connector.
2. Negative (-) battery cable. Tighten Negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).