Dashboard Center Panel

Dashboard Center Panel Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014

NOTE:
- Take care not to scratch the dashboard and related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.




1. Remove the screws from the bottom of the dashboard center panel (A).




2. Pull out on the bottom of the dashboard center panel (A) to create a gap between the dashboard and panel. Gently pull out along the panel to release the clips, then remove the panel. Disconnect the hazard warning switch connector (B).
3. Install the panel in the reverse order of removal, and note these items:
- Make sure the hazard warning switch connector is plugged in properly.
- Replace the clip if it's damaged.
- Push the clips into place securely.