Passenger's Vent Panel Removal/Installation

Passenger's Vent Panel Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the dashboard and related parts.

1. Open the passenger's tray lid.
2. Remove the passenger's vent panel (A).
1. From the tray lid opening, pull the left side edge of the panel out by hand.
2. Pry the front bottom of the panel slightly you to detach the lower clips.






3. Pull the lower portion of the passenger's vent panel (A) partially out by hand. Detach the upper clips by pulling the middle and upper portions of the panel toward you.






4. If necessary, remove the screws, then remove the passenger's vent (A) from the passenger's vent panel (B).






5. Install the panel in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.