General Specifications

Cylinder Head

Torque in sequence 39 Nm (4.0 kgf-m, 29 lbf-ft).





After torquing, tighten all cylinder head bolts in two steps (90° per step). If you are using a new cylinder head bolt, tighten the bolt an extra 90°.





Measure the diameter of each cylinder head bolt at point A and point B.





If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt.

Surface Variation

Warpage

If warpage is less than 0.05 mm (0.002 in.) cylinder head resurfacing is not required.
If warpage is between 0.05 mm (0.002 in.) and 0.2 mm (0.008 in.), resurface the cylinder head.
Maximum resurface limit is 0.2 mm (0.008 in.) based on a height of 104 mm (4.09 in.).








Camshaft





Camshaft Pulley/Gear