A/T Clutch Pressure Control Solenoid Valve B and C Replacement

A/T Clutch Pressure Control Solenoid Valve B and C Replacement
1. Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
2. Remove the splash shield.
3. Disconnect the connectors from A/T clutch pressure control solenoid valves B and C.





4. Remove A/T clutch pressure control solenoid valves B and C.
5. Remove the ATF joint pipes (A), the O-rings (D), and the gasket (E).
6. Clean the mounting surface, the fluid passage of the solenoid valve body, and transmission housing.
7. Install a new gasket on the transmission housing with the blue side toward the transmission housing and the white side toward the valve body mounting surface. Then install the ATF joint pipes.
8. Install new O-rings over the ATF joint pipes.
9. Install A/T clutch pressure control solenoid valve B and C.
10. Check the connectors for rust, dirt, or oil, then connect the connectors securely.
11. Install the splash shield.