Ignition Switch: Service and Repair

CAUTION:
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
Whenever the ignition switch ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.






1. Remove the dashboard lower cover and knee bolster.






2. Remove the steering column covers






3. Disconnect the connectors from the switch.






4. Remove the column holder mounting bolts and nuts
5. Lower the steering column assembly.






6. Center punch each of the two shear bolts, and drill their heads off with a 5 mm (3/16 in) drill bit.

CAUTION: Do not damage the switch body when removing the shear bolts.

7. Remove the shear bolts from the switch body, then remove the switch assembly.






8. Remove the three screws, and replace the electrical switch.
9. Reverse procedure to install.