Set/Resume Switch Test/Replacement

1. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
2. Disconnect battery ground cable, then the positive cable.
3. Ensure wheels are in straight ahead position, then remove lower instrument panel cover.

Fig. 37 Test Harness "C" Installation. W/Air Bag:

4. Disconnect cable reel harness 6-P connector from air bag harness, then connect test harness C only to cable reel harness, Fig. 37.

Fig. 38 Set/Resume Switch Test. W/Air Bag:

5. Check for continuity between terminals of test harness C in each switch position, Fig. 38.

Fig. 39 Set/Resume Switch Cover Removal:

6. Check for continuity between terminals of test harness C in each switch position, Fig. 39.

Fig. 40 Set/resume Switch Steering Wheel Location Test. W/Air Bag:

7. Check for continuity between terminals in each switch position, Fig. 40.
8. If there is no continuity in any position, replace set/resume switch.
9. If there is continuity in every switch position, replace cable reel.
10. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.