Transmission Position Sensor/Switch: Adjustments

1. Shift to "P" position, and loosen the nuts.
2. Slide the switch in the direction of "D" position [within 2.0 mm (0.079 in)] until there is continuity between No. 7 and No. 10 terminals in the range of free play of the shift lever.
3. Recheck for continuity between each of the terminals.

NOTE:
- If adjustment is not possible, check for damage to the shift lever detent and/or bracket. If there is no damage, replace the A/T gear position switch.
- The engine should start when the shift lever is in position "N" in the range of free play.