Cruise Control Servo Cable: Service and Repair

Actuator/Cable Replacement

1. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
2. Disconnect battery ground cable.

Fig. 44 Actuator Cable Components:

3. Pull back boot and loosen locknut, then disconnect cable from bracket, Fig. 44.
4. Disconnect cable end from actuator rod.
5. Disconnect 4-P connector.
6. Pull ventilation hose from grommet.
7. Disconnect vacuum hose from check valve.
8. Remove two actuator mount attaching bolts, then the actuator with bracket and reservoir.
9. Disconnect cable end from linkage over accelerator pedal, then turn grommet 90° in firewall and remove cable.
10. Reverse procedure to install, adjusting actuator cable as necessary.
11. On models equipped with radio coded theft protection system, refer to Vehicle Damage Warnings for system disarming and arming procedures. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.