Defogger Wire Repair

NOTE: Repair section must be no longer than one inch.

1. Lightly scour the area around the break with fine steel wool, then clean it with alcohol.

Defogger Wire Repair:

2. Carefully mask both edges of the broken portion of the defogger wire with cellophane tape.

Defogger Wire Repair:

3. Using a small brush, apply a heavy coat of silver conductive paint extending about 1/8 in. on both sides of the break. Allow 30 minutes to dry.

NOTE: Thoroughly mix paint before use.

4. Check for proper operation with a voltmeter (approximately 6 V at the mid-point).
5. Apply a second coat of paint in the same manner. Let it dry three hour before you remove the tape.