Rear Suspension

CAUTION:
- Replace the self-locking nuts after removal.
- The vehicle should be on the ground before any bolts or nuts connected to rubber mounts or bushings are tighten.





NOTE:
- Make sure the toe adjusting bolts on the compensator arm are installed in the same direction.
- "(Arrow Pointing Upward) UP L" or "(Arrow Pointing Upward) UP LH G" or "(Arrow Pointing Upward) UP LK" or "(Arrow Pointing Upward) UP LS" is stamped on the left upper arm and "(Arrow Pointing Upward) UP R" or "(Arrow Pointing Upward) UP RH G" or "(Arrow Pointing Upward) UP RK" or "(Arrow Pointing Upward) UP RS" on the right upper arm.
- The right and left compensator arm are symmetrical. Install so the "(Arrow Pointing Upward) UP" mark stamped side faces forward.
- After installing the suspension arm, check the rear wheel alignment, and adjust if necessary.