Glove Box

Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations, and precautions and procedures in the SRS section before performing repairs or service.

NOTE: Take care not to scratch the dashboard and related parts.

1. Remove these items:
- Dashboard center lower cover.
- Passenger's dashboard lower cover




2. Remove the screws from bottom of the glove box.




3. Wrap a flat-tip screwdriver with protective tape, and apply protective tape around the related pants, to prevent damage. Insert a flat-tip screwdriver in the notch (A) of the cap (B), and release the hooks (C) by prying up the cap (B).
4. Remove the screws.




5. Release the hooks (A), then pull down on the striker (B) to remove the glove box. Disconnect the glove box light connector (C).
6. Install the glove box in the reverse order of removal, and make sure the glove box light connector is plugged in properly.