Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2001 >> Accord EX Sedan L4-2254cc 2.3L SOHC (VTEC) MFI >> Repair and Diagnosis >> Restraints and Safety Systems >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair >> OPDS Unit Replacement

OPDS Unit Replacement

OPDS Unit Replacement

NOTE: Review the seat replacement procedure before performing repairs or service.

Removal

1. Disconnect the negative battery cable, and wait at least 3 minutes before beginning work.
2. Disconnect the side airbag harness 2P connector.
3. Remove the seat assembly (Sedan), (Coupe), and seat-back cover (Sedan), (Coupe).
4. Remove the cover (A), then disconnect the OPDS unit harness 8P and sensor connectors from the OPDS unit.




5. Remove the three screws (B) and OPDS unit (C).

Installation




1. Place the new OPDS unit on the seat-back frame. Tighten the three screws (A), then connect the OPDS unit harness 8P and sensor connectors to the OPDS unit. Reinstall the cover.
2. Install the new seat-back cover (Sedan), (Coupe).
3. Install the seat assembly (Sedan), (Coupe), then connect the side airbag harness 2P connector.
4. Reconnect the battery negative cable.
5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
6. Initialize the OPDS unit.
7. After installing the OPDS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator light should come on for about 6 seconds and then go off.
pro multis · About Operation CHARM