Seat Belt Systems: Service Precautions

Please read the following precautions carefully before performing the airbag system service. Observe the instructions described, or the airbags could accidentally deploy and cause damage or injuries.

Except when performing electrical inspections, always turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at least three minutes before beginning work.

NOTE: The SRS unit memory is not erased even if the ignition switch is turned OFF or the battery cables are disconnected from the battery.

Use the replacement parts which are manufactured to the same standards as the original parts and quality. Do not install used SRS parts from another vehicle. Use only new parts when making SRS repairs.




Carefully inspect any SRS part before you install it. Do not install any part that shows signs of being dropped or improperly handled, such as dents, cracks or deformation.

Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the airbag and seat belt tensioner connectors.

Use only a digital multimeter to check the system. If it is not a Honda multimeter, make sure its output is 10 mA (0.01 A) or less when switched to the lowest value in the ohmmeter range. A tester with a higher output could cause accidental deployment and possible injury.

Do not put objects on the passenger's airbag.