P0117
DTC P0117: ECT Sensor Circuit Low Voltage1. Turn the ignition switch ON (II).
2. Check the ECT with the scan tool.
Is 302 °F (150 °C) or higher (or H-Limit in Honda mode of PGM Tester) or 0 V indicated?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the ECT sensor and the PCM.
3. Disconnect the ECT sensor 2P connector.
4. Check the ECT with the scan toot.
Is 302 °F (150 °C) or higher (or H-Limit in Honda mode of PGM Tester) or 0 V indicated?
YES - Go to step 5.
NO - Replace the ECT sensor.
5. Turn the ignition switch OFF.
6. Disconnect PCM connector A (31P).
7. Check the continuity between the ECT sensor 2P connector terminal No.2 and body ground.
Is there continuity?
YES - Repair short in the wire between the PCM (A13) and the ECT sensor.
NO - Substitute a known-good PCM and recheck. If normal voltage is indicated, replace the original PCM.