Washer Fluid Level Switch: Testing and Inspection

Washer Fluid Level Switch Test - Canada

1. Remove the right inner fender.




2. Disconnect the 2P connector (A) from the washer level switch.
3. Remove the washer fluid level switch from the washer reservoir.

NOTE: Fluid may flow out of the opening.

4. Check for continuity between the No.1 and No.2 terminals in each float position (B).
- There should be continuity when the float is down.
- There should be no continuity when the float is up.

5. If the continuity is not as specified, replace the switch.