Front Door Window Glass: Service and Repair
Front Door Glass and Regulator Replacement1. Remove these items:
- Mirror mount cover, power mirror, manual mirror
- Door panel
2. Remove the screws securing the pull pocket bracket (A). On power window models, remove the nut securing the center stiffener (B).
3. Remove the plastic cover.
4. Carefully raise the glass until you can see the bolts, then remove them. Carefully pull the glass out through the window slot. Take care not to drop the glass inside the door.
5. Disconnect and detach the connector (A) and harness clip (B) from the door (power window models). Remove the bolts (C, D) and loosen the bolts (E), then remove the regulator (F) through the hole in the door.
6. Grease all the sliding surfaces of the regulator (A) where shown.
7. Install the glass and regulator in the reverse order of removal, and note these items:
- Roll the glass up and down to see if it moves freely without binding.
- Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
- Adjust the position of the glass as necessary.