Display Unit Buttons Do Not Work
Special Tools RequiredTest harness 07LAJ-PT3020A
Display unit buttons do not work
NOTE:
- Always check the connectors for poor connections or loose terminals.
- Before troubleshooting, get the navigation system anti-theft codes.
- After troubleshooting, enter the navigation system anti-theft codes.
1. Turn the ignition switch to ACC (I).
2. Measure the voltage between body ground and display unit connector B (20P) terminals No.1 and No.2 individually.
Is there battery voltage?
YES - Go to step 3.
NO - Repair open in the wire between the passenger's under-dash fuse/relay box and the display unit.
3. Check for continuity between display unit connector B (20P) terminal No.10 and body ground.
Is there continuity?
YES - Go to step 4.
NO - Repair the open in the wire between the display unit and body ground (G501).
4. Turn the ignition switch OFF.
5. Disconnect the navigation unit and display unit connectors.
6. Check for continuity between body ground and display unit connector B (20P) terminals No.5 and No.15 individually.
Is there continuity?
YES - There is a short to body ground in the circuit between the display unit and the navigation unit. Replace the affected shielded harness.
NO - Go to step 7.
7. Check for continuity between display unit connector B (20P) terminal No.5 and navigation unit connector B (16P) terminal No.7.
Is there continuity?
YES - Go to step 8.
NO - There is an open the circuit between the display unit and the navigation unit. Replace the affected shielded harness.
8. Check for continuity between display unit connector B (20P) terminal No.15 and navigation unit 16P connector B (16P) terminal No.15.
Is there continuity?
YES - Replace the display unit.
NO - Repair open in the wire between the display unit and the navigation unit.