Body Control Systems: Description and Operation

Multiplex Control System

System Descriptions

The multiplex control system has four internal functions:
- Multiplexing (send multiple signals over shared wires).
- Wake up/sleep modes (runs at full power only on demand to reduce battery draw).
- Fail-safe (fixes or ignores faulty signals).
- Self diagnosis (Mode 1 for the system, Mode 2 for input lines).

The system controls the function of the following circuits.
- Engine Oil Pressure Indicator.
- Seat Belt Reminder.
- Lights on Reminder.
- Key-in Reminder.
- Key Light Timer.
- Dash Lights Brightness Control.
- Entry Light Control (EX and EXL models).
- Automatic Lights-off (EX and EXL models).
- Power Window (including key-off timer operation).
- Wiper/Washers (including speed sensitive intermittent wiper).
- Keyless/Power Door Locks.
- Interlock.
- Factory Security Alarm System ('01-03 EX and '02-03 EXL models).

Multiplex Communication

To reduce the number of wire harnesses, digital signals are sent via shared multiplex communication lines rather than sending normal electrical signals through individual wires.
- The input signals from each switch are converted to digital signals at the central processing unit (CPU) The digital signals are sent from the transmitter unit to the receiver unit as serial signals.
- The transmitted signal is converted to a switch signal at the receiver unit, and it operates the related component.
- There are exclusive communication lines between each of the multiplex control units.
- Door <-> Driver's (between the door and the driver's multiplex control units) Wire color BRN.
- Driver's <-> Passenger's (between the driver's and the passenger's multiplex control units) Wire color: PNK.

The control units always communicate via these lines when the system is operating, and they stop communicating when the system is OFF.

Wake-up and Sleep

The multiplex control system has "wake-up" and "sleep" functions to decrease parasitic draw on the battery when the ignition switch is OFF.
- In the sleep mode, the multiplex control unit stops the functions (communication and CPU control) when it is not necessary for the system to operate.
- As soon as any operation is requested (for example, door is unlocked), the related control unit in the sleep mode immediately wakes up and begins to function This control unit also sends a wake-up signal to the other control units via the communication lines.
- When the ignition switch is turned OFF, and driver's or front passenger's door is opened then closed, there is about a 10 second delay before the control units go from the wake-up mode to the sleep mode.
- If any door is open, the sleep mode will not function.
- If a key is in the ignition switch, the sleep mode will not function.
- If one of the key cylinder switch inputs is shorted, the sleep mode will not function.

Fail-safe

To prevent improper operation, the multiplex control system has a fail-safe function In the fail safe mode, the output signal is stopped when any part of the system malfunctions (for example, a faulty control unit or communication line).
Each control unit has a hardware fail safe function that stops the output signal when there is any CPU malfunction, and a software fail safe function that ignores the signal from the malfunctioning control unit and allows part of the system with no defect to operate normally.