Hazard Warning Switch: Testing and Inspection

Hazard Warning Switch Test

With Navigation System:

1. Remove the center panel.

2. Disconnect the 10P connector (A) from the hazard warning switch (B).
3. Push out the hazard warning switch from behind the center panel (C).

4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity is not as specified, replace the switch.
6. If necessary, check the illumination bulb (D).

Without Navigation System:

1. Remove the instrument panel.

2. Disconnect the 10P connector (A) from the hazard warning switch (B).
3. Pull the hazard warning switch out from the clock (C).