Fuel Pump: Service and Repair

Fuel Pump Replacement

Special Tools Required
Fuel tank assembly wrench 07XAA-001010A

1. Remove the rear seats and carpet.
2. Remove the access panel from the floor.
3. Turn the ignition switch OFF, then disconnect the fuel tank unit 5P connector.
4. Remove the fuel fill cap.
5. Relieve fuel pressure.
6. Disconnect the quick-connect fittings from the fuel tank unit.




7. Using the tool, loosen the fuel tank unit locknut (A).




8. Remove the bracket (A), the fuel filter (B), the fuel gauge sending unit (C), the case (D), and the wire harness (E).
9. When connecting the fuel pump, make sure the connection is secure and the suction filter (F) is firmly connected to the fuel pump (G).
10. Install the unit in the reverse order of removal with a new base gasket, then check these items:
- When connecting the wire harness, make sure the connection is secure and the connector (H) is firmly locked into the place.
- Do not push the lower part of the suction filter.
- When installing the fuel gauge sending unit, make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.
- When installing the fuel tank unit, set the marks (J) between the fuel tank (K) and the fuel tank unit (L).