Front Impact Sensor

Front Impact Sensor Replacement

Removal

NOTE:
- Removal of the front impact sensor must be performed according to the precautions/procedures described at the beginning of this section.
- Before disconnecting the front impact sensor 2P connector(s), disconnect the driver's and front passenger's airbag 4P connectors, and both seat belt tensioner 2P connector(s).
- Do not turn the ignition switch ON (II), and do not connect the battery cable while replacing the front impact sensor.

1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Remove the front bumper.




3. Disconnect the side wire harness 2P connector (A), and remove the two Torx bolts (B) using a Torx T30 bit, then remove the front impact sensor (C).

Installation

NOTE:
- Be sure to install the harness wires so they are not pinched or interfering with other parts.
- Do not turn the ignition switch ON (II), and do not connect the battery cable while replacing the front impact sensor.




1. Install the new front impact sensor with new Torx bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).
2. Reconnect the battery negative cable.
3. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off.