Stall Speed Test
Test1. Engage the parking brake, and block the front wheels.
2. Connect a tachometer to the engine, and start the engine.
3. Make sure the A/C switch is OFF.
4. After the engine has warmed up to normal operating temperature (the radiator fan comes on), shift to 2 position.
5. Fully press the brake pedal, and accelerator pedal for 6 to 8 seconds, and note the engine speed. Do not move the shift lever while raising engine speed.
6. Allow 2 minutes for cooling, then repeat the test in D, 1, and R positions.
NOTE:
^ Do not test stall speed for more than 10 seconds at a time.
^ Stall speed tests should be used for diagnostic purposes only.
^ Stall speed should be the same in D, 2, 1, and R positions.
^ Do not test stall speed with the A/T pressure gauges installed.
Stall Speed rpm:
Specification: 2,250 rpm
Service Limit: 2,100 - 2,400 rpm