Programming and Relearning

Calibrating the Moonroof

2-door

NOTE: Moonroof calibration is required if any of the conditions listed below occur:

- The ignition switch is turned OFF while operating the moon roof (pressing the open/close switch). As a countermeasure, if the ignition switch is returned to the ON (II) position within 10 minutes, and moonroof operation is continued, calibration will not necessary.

NOTE: If a door is opened during the 10 minutes period, the calibration will be required.

- The moonroof is manually operated using the moonroof wrench with the battery dead or disconnected.
- The moonroof motor is replaced with a new one.
- The moonroof motor is removed from the moonroof assembly and operated before it is reinstalled.

Moonroof glass is positioned in the OPEN position (or partially open)

1. Press the moonroof OPEN switch until the moonroof stops in its fully open position.
2. Release the moonroof OPEN switch.
3. Press the moonroof OPEN switch again for about 13 seconds.

NOTE: Keep pressing the switch even through the moonroof motor continues to function.

4. Calibration is complete. The moonroof will automatically move to the regular preset fully open position and come to stop.

Moonroof glass is positioned in the TILT position

1. Press the moonroof OPEN switch until the moonroof glass stops in its fully open position.
2. Release the moonroof OPEN switch.
3. Press the moonroof OPEN switch for about 13 seconds.

NOTE: Keep pressing the switch even through the moonroof glass will repeat an inching behavior (moving 40 mm, then stopping for 0.4 seconds)

4. Calibration is complete. The moonroof will automatically move to the regular preset fully open position and come to stop.

Moonroof motor is replaced

1. Open the moonroof to its fully open position manually with the moonroof wrench.
2. Remove the moonroof motor.

NOTE: If you have accidentally moved the moonroof glass after the removal of the moonroof motor, return the moon roof to its fully open position.

3. Install the new moonroof motor.
4. Perform the moonroof OPEN position calibration procedure.
5. Within 5 seconds after completion of the moonroof calibration, press the moonroof OPEN switch again. After 3 seconds the moonroof glass will move toward the fully closed position.
6. Release the moonroof OPEN switch.

NOTE: The moonroof glass will move toward the fully closed position even though the open switch is being pressed. Allow it to move until it reaches the fully closed position.

NOTE: Step 5 is only applicable if a new motor is installed, and must not be applied to the original motor. The original motor memorized the initial position data and does not require recalibration.