Programming and Relearning

TCS Pressure Sensor Neutral Position Memorization





1. With the ignition switch OFF, connect the HDS to the 16P Data Link Connector (DLC) (A) under the driver's side of the dashboard.
2. Short the SCS circuit to body ground using the HDS.
3. The HDS screen will display the message: "The SCS line has been shorted. Do you want to leave the SCS line shorted?" Choose YES.
4. Turn the ignition switch ON (II).
5. The ABS indicator comes on for 2 seconds.
6. Push the TCS OFF switch once within 2 seconds after the ABS indicator goes off.
7. Push the TCS OFF switch once within 2 seconds after the ABS indicator comes back on.
8. The TCS activation indicator blinks, and the system starts TCS pressure sensor neutral position memorization.
9. When the ABS indicator, TCS indicator and TCS activation indicator go off, the memorizing is done.

NOTE: On the left bottom side of the HDS screen you will notice "SCS" blinking during steps 4 to 9.

10. Disconnect the HDS from the DLC, or go back into the SCS Menu and remove the short from there.
11. If the indicators do not go off, retry step 10.