Under-Dash Fuse/Relay Box

Removal and Installation

SRS components are located, and the in this area. Review the SRS component locations, precautions and procedures in the SRS before performing repairs or service.

Removal

1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
2. Connect the HDS to the date link connector (DLC), and ground the SCS.
3. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.
4. Remove the left front door sill trim and left kick panel.
5. Disconnect the connectors from the fuse side of the under-dash fuse/relay box (A).




6. Remove the two mounting bolts and pull the fusel relay box away from the body.
7. Disconnect the connectors and remove the under-dash fuse/relay box.

NOTE: Some SRS harness connectors are spring-loaded lock type.

Installation

1. Connect the connectors to the under-dash fusel relay box, then install the under-dash fuse/relay box in the reverse order of removal.
2. Install the removed parts in the reverse order of removal.
3. Connect both the positive cable and negative cable to the battery.
4. Do the power window control unit reset procedure.
5. Enter the anti-theft codes for the radio and navigation system, then enter the customer's radio station presents.
6. Confirm that all systems work properly.