Dynamic Damper Replacement

Dynamic Damper Replacement

Special Tools Required
Bearing separator 07KAF-PS30200

Band type

1. Remove the inboard joint.

2. Remove the dynamic damper bands. Be careful not to damage the dynamic damper.
^ If the band is a welded type, cut the band.
^ If the band is a double loop type, lift up the band end, and push it into the clip.
^ If the band is a low profile type, pinch the band using a commercially available boot band pincers.





3. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damage to the dynamic damper.

4. Remove the dynamic damper. Be careful not to damage the dynamic damper.





5. Adjust the position of the new dynamic damper to the figure follow.

Note: Be careful not to swap the dynamic dampers. The right and left dynamic dampers are different.

6. Install the dynamic damper band.

7. Install the inboard joint.

Bandless type

1. Remove the inboard joint and outboard joint.





2. Remove the dynamic damper (A) using the special tool and a press as shown.





3. Mark the following position on the driveshaft (A).

Note:
^ Install the dynamic damper that has "S4X-003" mark (B) to the right driveshaft.
^ Install the dynamic damper that has "S3N-003" mark to the left driveshaft.





4. Install the dynamic damper (A) to the marked position using the special tool and a press as shown.

5. Install the inboard joint and outboard joint.