Dashboard Center Lower Cover

Dashboard Center Lower Cover Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014

A/T Model

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE: Take care not to scratch the dashboard and related parts.

1. Remove these items:
- Passenger's dashboard under cover
- Heater control panel




2. Open the pocket. Remove the screws (A) and clips (B) from the dashboard center lower cover (C).




3. Remove the dashboard center lower cover (A).
1. Pull out the parking brake lever portion of the cover to release the clips (B).
2. Pull out the cover to release the clips (C, D).
3. Disconnect the accessory power socket connector (E).




4. If necessary, remove the pocket (A) from the dashboard center lower cover (B).
1. Remove the bolts.
2. Release the stops (C) from the cover.
3. Pull out the hinges (D) from the cover.

5. Install the cover in the reverse order of removal, and note these items:
- Replace any damaged clips.
- Make sure the accessory power socket connector is plugged in properly.
- Push the clips into place securely.

M/T Model

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the dashboard and related parts.

1. Remove these items:
- Front seat center table
- Passenger's dashboard under cover
- Heater control panel




2. Remove the shift knob.




3. Using a trim tool, pry out the inside edge of the caps (A) to release the hooks (B), and pull out the caps to release the hooks (C), then remove the caps from both sides.




4. Remove the screws (A) and clips (B) from the dashboard center lower cover (C).




5. Remove the dashboard center lower cover (A).
1. Pull out the parking brake lever portion of the cover to release the clips (B).
2. Pull out the cover to release the clips (C, D).
3. Disconnect the accessory power socket connector (E) and coin pocket light connector.




6. If necessary, remove the screws, then separate the center console (A) and center lower cover (B).
7. Install the cover in the reverse order of removal, and note these items:
- Replace any damaged clips.
- Make sure the accessory power socket connector and coin pocket light connector are plugged in properly.
- Push the clips and hooks into place securely.