Mirror Holder

Mirror Holder Replacement

NOTE: Put on gloves to protect your hands.




1. Carefully push on the top edge of the mirror holder (A) by hand.
2. Put a shop towel (B) in the opening between the lower edge of the mirror holder and the mirror housing (C) to prevent scratches, and detach the bottom clips (D) with a flat-tip screwdriver (E) wrapped with protective tape.
3. Carefully pull out the bottom edge of the mirror holder to separate the adhesive (F), and then release the side clips (G).
4. Separate the mirror holder from the actuator (H) by releasing the hooks (I). If equipped, disconnect the mirror defogger connectors from the heater pad terminals.
5. If equipped, reconnect the mirror defogger connectors.
6. Reattach the hooks of the mirror holder to the actuator, then position the mirror holder on the actuator. Carefully push on the clip portions of the mirror holder until the mirror holder locks into place.
7. Check the actuator operation.