How to Enter the Self-Diagnosis Function
Entering the self-diagnosis function:
Before entering the self-diagnosis function, check the No.9 (10 A) fuse in the under-hood fuse/relay box and the No.10 (7.5 A) fuse in the under-dash fuse/relay box.
1. Push and hold the trip/reset button.
2. Turn the headlights ON.
3. Turn the ignition switch ON (II).
4. With in 5 sec., turn the headlights OFF, then ON and OFF again.
5. With in 5 sec., release the trip/reset button, then push and release the button three times.
NOTE:
- While in the self-diagnosis mode, the dash lights brightness controller operates normally.
- While in the self-diagnosis mode, the trip/reset button is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check.
- If the vehicle speed exceeds 1.2 mph (2 km/h) or the ignition switch is turned OFF, the self-diagnosis mode ends.