Engine Controls/Fuel System - MIL ON/DTC P0122 Set
04-008May 6, 2005
*Applies To:
2002-2004 CR-V - ALL*
Updated information is noted by asterisks.
MIL Comes on With DTC P0122
(Supersedes 04-008, dated March 30, 2004)
Updated information is noted by asterisks.
SYMPTOM
*The MIL is on, and DTC P0122 (throttle position sensor circuit low voltage) is set.*
PROBABLE CAUSE
The throttle position sensor in certain throttle bodies becomes contaminated due to a manufacturing defect.
CORRECTIVE ACTION
Replace the throttle body.
PARTS INFORMATION
*Throttle Body Kit:
P/N 06160-PPA-A11, H/C 8003774
Throttle Body Gasket:
P/N 17107-PNA-J01, H/C 6731210*
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Failed Part: P/N 16400-PPA-A11
H/C 6886584
Defect Code: 06601
Symptom Code: 03203
Skill Level: Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1. Replace the throttle body.
^ Refer to page 11-189 of the 2002-2004 CR-V Service Manual, or
* ^ Online, enter keyword THROTTLE BODY, and select Throttle Body Removal/Installation from the list.
NOTE:
The new throttle body does not require a throttle drum cap.*
2. Adjust the throttle cable.
* ^ Refer to page 11-187 of the 2001-2004 CR-V Service Manual, or
^ Online, enter keyword THROTTLE CABLE, and select Throttle Cable Adjustment from the list.*
3. Adjust the cruise control actuator cable.
^ Refer to page 4-44 of the 2001-2004 CR-V Service Manual, or
* ^ Online, enter keyword CRUISE ACTUATOR, and select Cruise Control Actuator Cable Adjustment from the list.*
4. Connect the HDS to the DLC (data link connector), and clear the DTC.
5. Do the idle learn procedure.
* ^ Refer to page 11-168 of the 2001-2004 CR-V Service Manual, or
^ Online, enter keyword ECM IDLE, and select ECM/PCM Idle Learn Procedure from the list.*
Disclaimer