Engine Controls - MIL ON/DTC P1163 Is Stored In Memory

04-013

October 22, 2011

Applies To:
2002-03 CR-V - ALL

CR-V: MIL Comes On With DTC P1163

(Supersedes 04-013, dated July 23, 2011, to update the information marked by the black bars and asterisks)

REVISION SUMMARY

*Under WARRANTY CLAIM INFORMATION, a flat rate was changed.*

SYMPTOM

The MIL is on and DTC P1163 (air fuel ratio sensor slow response) is set.

PROBABLE CAUSE

Some driving conditions may cause the ECM/PCM software to set DIG P1163. This is a software issue, and it is not an A/F (air/fuel ratio) sensor problem.

CORRECTIVE ACTION

Update the ECM/PCM with the software from the Interactive Network (iN) CD, March 2004 version or later.





WARRANTY CLAIM INFORMATION

REPAIR PROCEDURE

1. Use the HDS to read and clear the DTCs.

*2. Update the ECM/PCM software. with the Honda Interface Module (HIM). For updating instructions, Refer to Service Bulletin 01-023, Updating Control Units/Modules.*





Disclaimer