A/T, M/T - Vibration Accelerating From a Stop
04-070November 19, 2004
Applies To
Noise or Vibration When Accelerating From a Stop
SYMPTOM
There is a noise or vibration when accelerating from a stop.
PROBABLE CAUSE
The transmission mount limiter tabs are out of position.
CORRECTIVE ACTION
Reposition the limiter tabs, and glue them to the transmission mount.
WARRANTY CLAIM INFORMATION
In warranty: The normal warranty applies.
Operation Number: 112002
Flat Rate Time: 0.2 hour
Failed Part: P/N 50805-S9A-983
H/C 7114614
Defect Code: 02502
Symptom Code: 04216
Template ID: 04-070A
Skill Level: Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.
INSPECTION PROCEDURE
Inspect the transmission mount. The limiter tabs should be positioned as shown in step 2 of the REPAIR PROCEDURE. If the limiter tabs are out of position, proceed with REPAIR PROCEDURE. If the tabs are in the correct position, troubleshoot for other causes.
REPAIR PROCEDURE
1. Open the hood.
2. With your hands, rotate the limiter tabs until they are positioned as shown.
3. With your finger, roll back the upper loop of the limiter tab, and put a dab of commercially available super glue (cyanoacrylate adhesive) between the loop and the mount. Do this for both limiter tabs.
Disclaimer