Rear Wiper Control Unit Input
Rear Wiper Control Unit Input Test1. Remove the right rear side trim panel.
2. Disconnect the 12P connector (A) from the control unit (B).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, go to step 4.
Part 1:
Part 2:
4. Reconnect the connector and make these input tests at the connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, go to step 5.
5. Disconnect the connector, and make these input tests at the connector.
- If all the input tests prove OK, the control unit must be faulty; replace the rear wiper control unit.