SRS Indicator Stays ON:

1. Disconnect the battery negative cable, and wait for 3 minutes.
2. Disconnect the driver's airbag 4P connector.
3. Disconnect the front passenger's airbag 4P connector.
4. Disconnect both seat belt tensioner 2P connectors.
5. Disconnect SRS unit connector A (18P) from the SRS unit.




6. Remove the gauge assembly. Disconnect gauge assembly connector A (30P) from the gauge assembly.




7. Check resistance between the No, 19 terminal of gauge assembly connector A (30P) and the No. 5 terminal of SRS unit connector C (8P). There should be 1 Ohm or less.

Is the resistance as specified?

YES - Faulty SRS indicator circuit in the gauge assembly or poor contact at gauge assembly connector A (30P); check the connection. If the connection is OK, replace the gauge assembly.

NO - Open in the dashboard wire harness or floor wire harness; replace the faulty harness.