How to Troubleshoot Vtm-4 Control Unit
How to Troubleshoot Circuits at the VTM-4 Control UnitSpecial Tools Required
Backprobe set 07SAZ-001000A (two required)
1. Remove the jack cover and jack.
2. Remove the VTM-4 control unit.
3. Inspect the circuit on the VTM-4 control unit, according to the DTC troubleshooting using the special tools and a digital multimeter or an analog circuit tester.
4. Connect the backprobe adapters (A) to the stacking patch cords (B), and connect the cords to the multimeter or and analog circuit tester (C). Using the wire insulator as a guide for the contoured-tip of the backprobe adapter, gently slide the tip into the connector from the wire side until it comes in contact with the terminal end of the wires.