Fluid Line/Hose: Service and Repair

ATF Cooler Hoses Replacement
1. Slide the ATF cooler hoses (A) on the ATF filter (B) until they are 5 - 6 mm (0.20 - 0.24 inch) (C) away from the filter housing.





2. Secure the hoses with the clips (D) at 10 - 12 mm (0.4 - 0.5 inch) (E) from the filter housing.
3. Slide the ATF cooler hoses (F) over the ATF cooler lines (G), then secure the hoses with the clips (H) at 2 - 4 mm (0.1 - 0.2 inch) (I) from the hose ends.
4. Install the hose clamp (J) at the marks (K) on the ATF cooler hoses.