DTC Troubleshooting
DTC P0341: CMP Sensor and CKP Sensor Incorrect Phase Detected1. Turn the ignition switch ON (II).
2. Do the DTC CLEAR in the CLEAR MENU with the Honda PGM Tester or the HDS.
3. Start the engine.
4. Check for Temporary DTCs or DTCs in the DTCs MENU with the Honda PGM Tester or the HDS.
Is DTC P0341 indicated?
YES - Go to step 9.
NO - Go to step 5.
5. Do the VTC TEST in the INSPECTION MENU with the Honda PGM Tester or the HDS.
Is the result OK?
YES - Go to step 6.
NO - Go to step 9.
6. Test-drive at a steady speed between 19 - 38 mph (30 - 60 km/h) for 10 minutes.
7. Check the VTC STATUS in the DATA LIST with the Honda PGM Tester or the HDS.
Does it indicate ON?
YES - Go to step 8.
NO - Go to step 6 and recheck.
8. Monitor the OBD STATUS for DTC P0341 in the DTCs MENU with the Honda PGM Tester or the HDS.
Does the screen indicate FAILED?
YES - Go to step 9.
NO - If the screen indicates PASSED, intermittent failure, system is OK at this time. If the screen indicates NOT COMPLETED, go to step 6 and recheck.
9. Turn the ignition switch OFF,
10. Test the VTC oil control solenoid valve.
Is the VTC oil control solenoid valve OK?
YES - Go to step 11.
NO - Replace the VTC oil control solenoid valve, then go to step 14.
11. Check the camshaft timing.
Is the camshaft timing OK?
YES - Go to step 12.
NO - Reset the camshaft timing, then go to step 14.
12. Check for damage to the cam chain.
Is the cam chain damaged?
YES - Replace the cam chain, then go to step 14.
NO - Go to step 13.
13. Inspect the VTC actuator.
Is the result OK?
YES - Go to step 14.
NO - Replace the VTC actuator, then go to step 14.
14. Turn the ignition switch ON (II).
15. Do the ECM/PCM RESET in the CLEAR MENU with the Honda PGM Tester or the HDS.
16. Do the CKP PATTERN CLEAR in the CLEAR MENU with the Honda PGM Tester or the HDS.
17. Do the ECM/PCM idle learn procedure.
18. Do the CKP pattern learn procedure.
19. Test-drive at a steady speed between 19 - 38 mph (30 - 60 km/h) for 10 minutes.
20. Check for Temporary DTCs or DTCs in the DTCs MENU with the Honda PGM Tester or the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P0341 is indicated, check for poor connections or loose terminals at VTC oil control solenoid valve and the ECM/PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.
NO - Go to step 21.
21. Monitor the OBD STATUS for DTC P0341 in the DTCs MENU with the Honda PGM Tester or the HDS.
Does the screen indicate PASSED?
YES - Troubleshooting is complete.
NO - If the screen indicates FAILED, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM, then go to step 1. If the screen indicates NOT COMPLETED, go to step 19 and recheck.