Driver's Seat Position Sensor Replacement
Driver's Seat Position Sensor ReplacementRemoval
NOTE:
- Removal of the driver's seat position sensor must be performed according to the precautions/procedures described at the beginning of SRS.
- Before disconnecting the driver's seat position sensor 2P connector, disconnect the driver's airbag 4P connector.
- Do not turn the ignition switch ON (11), and do not connect the battery cable while removing the driver's seat position sensor.
- Review the seat replacement procedure before performing repairs or service.
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Remove the driver's seat assembly.
3. Remove the cover (A).
4. Using a Torx T30 bit, remove the Torx bolt (B), then remove the driver's seat position sensor (C).
Installation
NOTE:
- Be sure to install the harness wires so they are not pinched or interfering with other parts.
- Do not turn the ignition switch ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.
1. Install the new driver's seat position sensor with a Torx bolt (A), then connect the driver's seat subharness 2P connector to the driver's seat position sensor (B). Then reinstall the cover (C).
2. Reinstall the driver's seat assembly.
3. Reconnect the battery negative cable.
4. Check the operation of the driver's seat position sensor with the HDS.