Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2006 >> Civic L4-1.3L Hybrid >> Repair and Diagnosis >> Transmission and Drivetrain >> Continuously Variable Transmission/Transaxle >> Service and Repair >> Overhaul (Transmission) >> 1. Lower Valve Body Disassembly & Service

1. Lower Valve Body Disassembly & Service

Lower Valve Body

CVT Start Clutch Pressure Control Valve Removal/installation





1. Disconnect the CVT start clutch pressure control valve connector (A).
2. Remove the CVT start clutch pressure control valve (B).
3. Check that the filter (C) is in good condition, replace it if it is clogged or damaged.
4. Install the CVT start clutch pressure control valve with the dowel pins (D) and separator plate (E) on the lower valve body (F).
5. Connect the CVT start clutch pressure control valve connector.

CVT Drive Pulley Pressure Control Valve Removal/installation





1. Remove the solenoid harness clamp (A).
2. Disconnect the CVT drive pulley pressure control valve connector (B).
3. Remove the seven bolts, and remove the CVT drive pulley pressure control valve (C). The CVT start clutch pressure control valve (D) can also be removed.
4. Check that the filter (E) is in good condition, replace it if it is clogged or damaged.
5. Install the CVT drive pulley pressure control valve with the dowel pins (F) and separator plate (G), and CVT start clutch pressure control valve with the dowel pins (H) and separator plate (I) on the lower valve body (J).
6. Connect the CVT drive pulley pressure control valve connector.
7. Install the solenoid harness clamp.

CVT Driven Pulley Pressure Control Valve Removal/Installation





1. Disconnect the CVT driven pulley pressure control valve connector (A) and inhibitor solenoid connector (B).
2. Remove the CVT driven pulley pressure control valve (C), and remove the inhibitor solenoid (D) from the CVT driven pulley pressure control valve.
3. Check that the filter (E) is in good condition, and replace it if it is clogged or damaged.
4. Replace the O-rings (F) on the inhibitor solenoid, if necessary.
5. Install the inhibitor solenoid on the CVT driven pulley pressure control valve.
6. Install the CVT driven pulley pressure control valve with the dowel pins (G) and separator plate (H) on the lower valve body (I).
7. Connect the CVT driven pulley pressure control valve connector and inhibitor solenoid connector.

Inhibitor Solenoid Removal/Installation





1. Disconnect the inhibitor solenoid connector (A).
2. Remove the inhibitor solenoid (B).
3. Install the inhibitor solenoid on the CVT driven pulley pressure control valve.
4. Connect the inhibitor solenoid connector.
pro multis · About Operation CHARM