Rear Seat Cover

Rear Seat Cover Replacement

NOTE:
- Take care not to tear the seams or damage the seat covers.
- Put on gloves to protect your hands.

Seat-back Cover

1. Remove the headrest.
2. Fold the seat-back forward.




3. Release the hooks (A), and with seat-back loops, unzip the seat-back cover (B) and release the hooks (C). It is not necessary to remove a seat-back bungee cord from the loops if the cover will be reinstalled.




4. Pull back the seat-back cover (A), and release the inside springs (B).




5. Pull out the headrest guides (A) while pinching the end of the guides, and remove them.




6. Pull back the edge of the seat-back cover (A) all the way around, then release all of the clips (B).
7. Remove the seat-back cover.




8. Install the seat-back cover in the reverse order of removal, and note these items:
- To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the hook, inside spring, and clips.
- Replace any clips (A) you removed with new ones using commercially available upholstery ring pliers (B).

Seat Cushion Cover

1. Remove the rear seat.
2. Remove these items from the rear seat:
- Seat-back
- Seat support
- Hinge lock
- (Latch Child Seat Anchor) cover, both sides




3. From under the seat cushion, release the hooks (A), and pull back the seat cushion cover (B).




4. Release the hooks (A) from the seat cushion frame.




5. Remove the hook (A) from the hook strap (B), and pull the hook strap out through the slit in the seat cushion cover. If necessary, remove the bolt (C), then remove the hook strap.
6. Remove the screw (D), and pull the strap (E) out.




7. Release the hooks (A) securing the seat cushion cover (B) from the recline cover.




8. Pull back the seat cushion cover. Remove the screw (A), and pull the recline cover (B) down to release the hook (C).
9. Remove the nut (D), then remove the recline strap (E) from the recline adjuster lever (F).




10. Pull up on the center tray (A) to detach the clips, then remove the tray with the recline strap (B).




11. Pull back the edge of the seat cushion cover all the way around, and release the clips (A), then remove the seat cushion cover (B).




12. Install the seat cushion cover in the reverse order of removal, and note these items:
- To prevent wrinkles when installing a seat cushion cover, make sure the material is stretched evenly over the pad before securing the clips and hooks.
- Replace any clips (A) you removed with new ones using commercially available upholstery ring pliers (B).