Ignition Timing: Testing and Inspection
Ignition Timing Inspection1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC), and check for DTCs. If a DTC is present, diagnose and repair the cause before inspecting the ignition timing.
2. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or Neutral) until the radiator fan comes on, then let it idle.
3. Check the idle speed.
4. Jump the SCS line with the HDS.
5. Free the service loop from the wire harness, then connect the timing light to the service loop.
6. Aim the light toward the pointer (A) on the cam chain case. Check the ignition timing under a no load condition (headlights, blower fan, rear window defogger, and air conditioner are turned off).
7. If the ignition timing differs from the specification, update the engine control module (ECM)/powertrain control module (PCM) if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the system works properly, and the ECM/PCM was substituted, replace the original ECM/PCM.
8. Disconnect the HDS and the timing light
9. Secure the service loop to the wire harness with wire ties.