Cruise Control Set/Decel, Resume/Accel, Cancel Switch

Cruise Control Set/Decel, Resume/Accel, Cancel Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures, before performing repairs or service.

1. Remove the driver's airbag.




2. Remove the cover (A), then remove the cruise control set/decel, resume/accel, cancel switch (B).




3. Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, but switch failure occurred on the cruise control actuator input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the switch.