Seals and Gaskets: Service and Repair

Oil Seal Replacement
Special Tools Required
^ Oil seal driver 07GAD-PH70201
^ Oil seal driver 07JAD-PL90100
^ Attachment, 78 x 80 mm 07NAD-PX40100
^ Driver 07749-0010000

1. Remove the oil seals (A) from the differential housing.

NOTE: Be careful not to damage the differential carrier while prying out the seals.





2. Install the right side oil seal (A) squarely using the special tools. Installation depth of the oil seal is 9 mm (0.35 inch) below the machined edge of the differential carrier assembly. Be careful not to damage the lip of the oil seals.





3. Install the left side oil seal (A) squarely and flush with the machined edge of the differential carrier assembly using the special tools. Be careful not to damage the lip of the oil seal.





4. Remove the oil seal (A) from the torque control differential case (B).

NOTE: Be careful not to damage the shaft or case while prying out the seal.





5. Install the oil seal (A) squarely using the special tool (B). Be careful not to damage the lip of the oil seal.