Transfer Housing Tapered Roller Bearing Outer Race Replacement

Transfer Housing Tapered Roller Bearing Outer Race Replacement
Special Tools Required
^ Installer shaft, 14 x 165 mm 07JAF-SJ80110
^ Installer nut, 14 mm 07JAF-SJ80120
^ Bearing installer attachment 07KAF-PS30120
^ Bearing installer attachment 07LAF-PZ70110
^ Oil seal driver attachment 07947-SD90101
^ Driver 07749-0010000

NOTE:
^ Coat all parts with manual transmission fluid (MTF) during reassembly.
^ Replace the tapered roller bearing and the bearing outer race as a set if either part is replaced.

1. Remove the tapered roller bearing outer race (A) from transfer housing (B) by heating the housing to almost 212°F (100°C) using a heat gun (C). Do not heat the housing over 212°F (100°C).





Bearing Outer Race Locations





2. Install the 57 mm tapered roller bearing outer race using the special tools.





3. Install the 62 mm tapered roller bearing outer race and 50 mm tapered roller bearing outer race using the special tools.