DTC 61
DTC 61: IG1 Voltage Low1. Test the battery and connections.
Is the battery OK?
YES - Go to step 2.
NO - Replace the battery; test the charging system, repair any problems found with the charging system before proceeding.
2. Disconnect the VSA modulator-control unit 46P connector.
3. Turn the ignition switch ON (II).
4. Measure the voltage between VSA modulator control unit 46P connector terminal No. 40 and body ground.
Is there battery voltage?
YES - Go to step 5.
NO - Repair open or high resistance in the wire between No. 31 (7.5 A) fuse in the under-dash fuse/relay box and the VSA modulator-control unit.
5. Reconnect the VSA modulator-control unit 46P connector.
6. Clear the DTCs using the HDS.
7. Turn the ignition switch OFF, then disconnect the HDS.
8. Test-drive the vehicle at 10 mph (15 km/h) or more.
Does the ABS indicator come on, and is DTC 61 indicated?
YES - Check for loose or poor connections in the VSA modulator-control unit 46P connector. If connections are good, replace the VSA modulator control unit.
NO - Intermittent failure, the system is OK at this time. Check for loose or poor connections.